Thrustmaster T3PA Add-On Manuel d'utilisateur télécharger pdf (Page 9)

8/11

- Using the included 2.5 mm Allen key (4), attach the unit using the attachment screw (3) and the

small central screw thread located on the underside of the pedal set.

The “CONICAL RUBBER BRAKE” mod is now installed!

Adjusting the brake pedal’s RANGE of travel and STRENGTH of resistance

By slightly unscrewing the nut (5), you can further strengthen the resistance of the brake pedal by

moving the conical stop (2) closer to the back of the pedal’s arm (if necessary, use a 14 mm wrench

or pliers to re-tighten the nut and maintain the selected position). The closer the conical stop is

positioned to the back of the pedal’s arm, the greater the strength of resistance will be.

Note: When the conical stop is very close to the back of the brake pedal’s arm, you may ex perience

difficulties in reaching the max imum calibration value. Should that be the case:

* Slowly, press very hard on the brake pedal so as to reach the max imum value (if necessary, stand

very briefly on the pedal – just for a second), then release the pressure; or else

* Move the conical stop a bit farther away from the back of the brake pedal’s arm.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 133 134

Pas de commentaire

Thrustmaster T3PA Add-On Manuel d'utilisateur Page 9